drawing spirals

About Truespace Archives

These pages are a copy of the official truespace forums prior to their removal somewhere around 2011.

They are retained here for archive purposes only.

drawing spirals // Archive: Tech Forum

1  |  

Post by Polyrhythmic // Jan 27, 2007, 2:48pm

Polyrhythmic
Total Posts: 23
I'm trying to use truespace as a template for a piece of art i'm working on. It involves a lot of precise angle/arc measurements. One of the main points are spirals and i wanted to do some in truespace so i could be as precise as possible, then capture the screen and then trace :( the spirals so I can get a glimpse of what I'm doing is gonna look like. Basically I wanna put a spiral in the center of each triangle, in this pic my triangles are off but I hope this gives an impression of where I'm goin. Any suggestions are welcome

Post by prodigy // Jan 27, 2007, 5:12pm

prodigy
Total Posts: 3029
pic
Aham.. i think how you can do this...

Let me try first..

Post by prodigy // Jan 27, 2007, 5:53pm

prodigy
Total Posts: 3029
pic
Let me know if this what you need to do..


4023


A spiral inside the triangle..


If is yes..


You must create a spiral inside on a new triangle as you like and glue both objects. Now using the remplace tool you can remplace all the objects for the new one without any job.. Or you can download my object and use for pratice.


4024




HOO i found this on the last minute, if you make right click over the remplace tool icon you can get this panel.. and you must select Keep target orientation.. Good point for the caligari team.. :D


4026


here is the model.. you can use in ts6.6.


Hope that help..


Other way is paint a spiral inside the triangles and remplace....
Awportals.com is a privately held community resource website dedicated to Active Worlds.
Copyright (c) Mark Randall 2006 - 2021. All Rights Reserved.
Awportals.com   ·   ProLibraries Live   ·   Twitter   ·   LinkedIn