Selec more points in TS6.6

About Truespace Archives

These pages are a copy of the official truespace forums prior to their removal somewhere around 2011.

They are retained here for archive purposes only.

Selec more points in TS6.6 // New Users

1  |  

Post by achilles // May 9, 2007, 12:20am

achilles
Total Posts: 24
Hallo,

is possible to select more than 1 control point of a curve or a poligon to manipulate them at the same time?

I havent't found this option.

Achille

Post by spacekdet // May 9, 2007, 7:14am

spacekdet
Total Posts: 1360
pic
For a curve, no. You can manipulate either one point or the entire curve at a time.
For polygons, you can select multiple points using any of the selection tools (lasso, rectangle, clicking on them, etc), or by holding Control key while selecting them. To de-select points from an already selected group, hold Shift key and click on them.

Post by achilles // May 9, 2007, 8:06pm

achilles
Total Posts: 24
This is a bad thing, many graphic programs permit to manipulate different points at the same time! Why TS not?

Bye.

Achille

Post by spacekdet // May 9, 2007, 9:20pm

spacekdet
Total Posts: 1360
pic
Well, it's only half bad.
Only NURBS have the limitation.

Post by Jack Edwards // May 9, 2007, 9:51pm

Jack Edwards
Total Posts: 4062
pic
I think soft select in 7.5 (and 7.11 too) in a lot of ways replaces the need for the old NURBs tools.


-Jack.
Awportals.com is a privately held community resource website dedicated to Active Worlds.
Copyright (c) Mark Randall 2006 - 2021. All Rights Reserved.
Awportals.com   ·   ProLibraries Live   ·   Twitter   ·   LinkedIn