Weightpaint sliders

About Truespace Archives

These pages are a copy of the official truespace forums prior to their removal somewhere around 2011.

They are retained here for archive purposes only.

Weightpaint sliders // Bugs

1  |  

Post by Tiles // Jun 1, 2008, 7:13am

Total Posts: 1037
There are the weightpaint settings with its sliders. When you right click into the workspace and drag vertically it changes the radius slider. From completely left to completely right.

When you do the same horizontally the magnitude slider gets changed. But not from completey left to completely right. It stops at 1.

I can enter very long values that goes completely over the range of the tool and over the range of the edit box. I would suggest to reset the values to the maximum when they are bigger than the maximum.

When i select the first value and hit enter, the last value gets selected. I have to hit enter again so that also this value gets accepted and the edit box finally looses focus.

Same fun counts for the second edit box and the third edit box.

Not a bug but a quirk, the values in the edit boxes are hard to select. The point between the values, the " . " makes trouble. Either you can select the part before or the " . " or the part after. Ah, edit boxes. I also had my fun with them in the past ... :D is a privately held community resource website dedicated to Active Worlds.
Copyright (c) Mark Randall 2006 - 2020. All Rights Reserved.   ·   ProLibraries Live   ·   Twitter   ·   LinkedIn